Page 1 of 1

ELIPTIC TANK SLOSHING

PostPosted: Mon May 04, 2009 4:46 am
by amlencasa
Hello everybody

I would like to know if it’s possible to simulate tank sloshing with SPHysics, and it’s possible to generate an elliptic tank section.

Thanks

Re: ELIPTIC TANK SLOSHING

PostPosted: Tue May 05, 2009 12:40 am
by arnom
Hello,

I think that is two times a yes. Not that I have simulated tank sloshing myself but my experience tells me that it should be possible.
The second yes also requires a little bit of explanation. It is not possible with traditional SPHysics, you will have to utilze the add-on MyGeo that has been described on this forum. You will need to program a little routine that describes the ellipse and it's movement but it definately is possible. I would like to provide a bit of code for you but unfortunately it's exam time for me so time is very limited at the moment. However if you have any questions feel free to ask.

Best,
Arno

Re: ELIPTIC TANK SLOSHING

PostPosted: Tue May 12, 2009 10:39 pm
by amlencasa
Many thanks

I’m going to try it. I hope that I will be able to do it because I not an expert user with visual studio.

Good luck with your exams

Regards

Re: ELIPTIC TANK SLOSHING

PostPosted: Wed May 13, 2009 2:07 am
by arnom
Got some code for you: http://sci.amconception.de/files/mygeo.f

I do not take any responsibility for that :) I just wrote it and didn't do any debugging, that's your job. But it should be a good starting point.

Re: ELIPTIC TANK SLOSHING

PostPosted: Fri Sep 25, 2015 3:05 am
by dolcevitak
Arnom,
I can't find mygeo.f. Do you send me through email? and my email is dolcevitak@163.com.
Thanks.